Do you want to remember your youth with hiking and dinner on fire? Make an unusual stove that will bring back pleasant memories!
What is required
- square tube (2 sizes)
- roulette
- square
- Bulgarian
- heat resistant paint
Instructions
The stove base consists of only 3 parts. It is better to use a square pipe with a cross section of 120 mm (100 mm is possible, but not less).
Let's start with the chimney detail.
It is necessary to saw off a piece of pipe 400 mm long with a bevel at 45 degrees at one of the ends.
Next, cut off the part called "blown". The length of this part is 350 mm, at one of the ends there is a bevel at 45 degrees.
The third part - "loader", is a similar piece of pipe (with a bevel) but the length of this part is 300 mm.
We fold the details as shown in the photo and mark the place of contact between the "chimney" and the "loader". It is necessary to prepare an opening in the chimney to create a combustion chamber.
Below the marked line we draw another one with some indentation, it is necessary to leave a margin for the joint and weld. Cut out the "window" as shown in the photo below.
After all operations, it is necessary to prepare the edges: remove burrs, clean, chamfer.
We start welding, grab at the corners and go through the seam along the entire length.
We clean the seams.
We weld the legs so that the stove does not tip over.
Strips can be cut from the plate cut out in the previous step and welded to the top of the "chimney". This will increase the pan support area.
We paint with heat-resistant spray paint.
The stove is ready! You can take it out into the street and start a "camp" dinner.
In the video below you can find detailed instructions. Please note that the measurements in the video are in inches.
