I mean, I planned the renovation before the upcoming wedding, and for a long time the desire to fulfill half of the walls under the brick, like in overseas interiors, has been "burning".
I ran into the nearest Leroy, shock … 1 square meter of "brick" costs 800 rubles.
I counted Quickly in my head:
50 squares x 800 p = 40,000 only for the stone itself. Plus a primer, glue, varnish.
Well, a simple plaster! Why so expensive ? And the gypsum is not very good in quality.
Having climbed on the Internet, I found a silicone mold for my stone, ordered it from the city of Omsk, found a special composition.
Prepared the table (must be set according to the level).
Be sure to cover everything around with a film, otherwise the whole floor will be in traces)
And so, I needed:
- Silicone molds.
- Soap solution.
- Screwdriver
- Mixer attachment.
- Dry mix - Sculptor.
- Bucket 5 l
- Wide Spatula.
Filled in and realized the consumption is just HUGE! For one form I used 2600 dry mix and 850 gr. Water ….. Although if you make G16 from gypsum, then it will take 2 times less!
After 20 minutes, I just pulled the "bricks" out of the mold.
After an hour and a half and 4 fillings, I made 1 sq. M. The prime cost with such an "elephant" consumption is 150 rubles per 1 sq. M.
Then I will make G 16 from gypsum, it is lighter and cheaper…..96 rubles. per Sq.m
So it turns out that in an hour and a half I saved 650 rubles. And saved as they say - earned.
Another way (video):
P.s Sorry for the spelling and punctuation.
